MANUAL Menu
In manual mode you have full control over the pump and valves. If you need to run the pump for a pool vacuum, simply turn it on here and start cleaning. You can also activate filtration and set a timer that, once expired, stops the system and switches SUNREG to the desired mode.
Pump
Pump
on/off
Turns the pump on or off. When switched on, the outlet will supply 230V. Maximum load is 2300W.
off
Heating
Heating circuit valve
on/off
Turns the heating circuit on or off. Water will then flow through the solar panels or circulate normally.
off
Filtration
Filtration circuit valve
on/off
If your system is equipped with a filtration bypass, the valve is opened during heating to avoid pressure loss caused by the sand filter.
off
Stopwatch
Manual mode stopwatch
0-12h
Used to run an action for a limited time. The stopwatch is set in 15‑minute steps. While the stopwatch is running, a blinking hourglass icon appears in the top‑right corner. You can display the remaining time by pressing . When the stopwatch finishes, all active actions are stopped and the device switches to AUTO or MAN mode according to the
Stpw action setting.
off
Stpw action
Action after stopwatch
MAN/AUTO
Defines what should happen after the stopwatch finishes, specifically which mode SUNREG should switch to.
AUTO
STOP all
Stop all
Turns off all devices and resets the stopwatch.
Exit MENU
Exit menu
Returns to the main screen. Exit is also performed automatically on any item if you forget to leave the menu.
Connecting SUNREG[Wi] to Wi-Fi
The process is simple. Once completed, you will receive a login code for the app.
Device display
AP running
...192.168.4.1
...192.168.4.1
1. Open Wi-Fi settings
On your phone, go to Settings → Wi-Fi. If you are already connected, disconnect.
Find the network SUNREG-Wi. No password is required.
2. Open the configuration page
Open your browser (Safari, Chrome…) and enter:
192.168.4.1
Tip: Make sure you are connected to the SUNREG-Wi network.
3. Configure the connection
- Select the Wi-Fi network you want to use.
- Enter the password for that network.
- Enter your email address. You will receive your login code for the app there.
AP running
...connected
...connected
Done! After confirmation, the device will connect to your network.