MANUAL Menu
In manual mode you have full control over the pump and valves. If you need to run the pump for a pool vacuum, simply turn it on here and start cleaning. You can also activate filtration and set a timer that, once expired, stops the system and switches SUNREG to the desired mode.
Pool Vac
Quick option for pool vacuuming. In one step it turns on filtration, disables heating, and starts the pump.
Pump
Turns the pump on or off. When switched on, the outlet will supply 230V. Maximum load is 2300W.
Heating
Turns heating
on (valve closed) or off (valve open) for the heating circuit. If the valve is turned on – the valve is closed. Water then flows through the solar panels. [i] The valve with controller 303 is open when voltage is present on the switch contact. In its idle state, the valve is closed – meaning heating is on.
Filtration
If your system is equipped with a filtration bypass, the valve is opened during heating to avoid pressure loss caused by the sand filter. If filtration is set to
on, the valve is closed. Warning! The valve is open whenever the switch contact is powered.
Stopwatch
Used to run an action for a limited time. The stopwatch is set in 15‑minute steps. While the stopwatch is running, a blinking hourglass icon appears in the top‑right corner. You can display the remaining time by pressing . When the stopwatch finishes, all active actions are stopped and the device switches to AUTO or MAN mode according to the
Stpw action setting.
Stpw action
Defines what should happen after the stopwatch finishes, specifically which mode SUNREG should switch to.
Exit MENU
Returns to the main screen. Exit is also performed automatically on any item if you forget to leave the menu.
Connecting SUNREG[Wi] to Wi-Fi
The setup process is simple. Once completed, you will receive a login PIN for the mobile app.
1. Open the Wi-Fi menu in Settings
Use the Up or Down arrow key to select on.
(on → off → exit → diag → exit)
AP SUNREG Wi |
192.168.4.1
192.168.4.1
2. On your phone
Open Wi-Fi Settings.
Select the SUNREG-Wi network. No password is required.
3. After connecting to the SUNREG-Wi network
Open your web browser (Safari, Chrome, etc.) and enter the following address:
192.168.4.1
Tip: Make sure you are connected to the SUNREG-Wi network.
4. Configure the connection
SUNREG will scan for available Wi-Fi networks.
- Select the Wi-Fi network you want to use.
- Enter the network password.
- Enter your email address. Your app PIN will be sent to this address.
AP running
...connected
...connected
Done! The device will now connect to your Wi-Fi network.